RV Electrical Systems – Good Info

Is the converter is operating any time you plug into a 120 volt AC system (30 Amp), does this mean you only have 22 amps to work with (30 minus 8 = 22.)?

What your RV converter does. When you plug your RV into an electrical source, or when you use the onboard generator, the converters job is to reduce 120 volts AC down to 12 volt DC to supply power to all of the 12 volt appliances and accessories in the RV. When you are not plugged into an electrical source your RV battery supplies the power to all of the 12 volt appliances and accessories in the RV. The converter basically prevents your RV battery from draining when you’re plugged in.

Two types of amperage draw concerning your RV. The AC amps we are using and the DC amps we are using.

When you plug your RV into an electrical source and use 120 volt appliances, eg.: the roof air conditioner, the microwave, the TV … you are drawing amps from the available supply at the campground, usually 30 or 50 depending on your RV electrical system and the electrical supply you are plugged into. When you’re plugged into an electrical source and you use DC appliances and accessories like fans, lights, pumps or the TV antenna booster you are drawing amps from the converter.

Simplified: When you plug your RV into a 30 amp electrical supply, you only use 120 volt appliances. You’re using the available amps from the 30 amp electrical supply for whatever 120 volt appliances are running, but the converter is drawing almost 0 amps because you’re not using any DC accessories. It will use a small amount for items like the LP gas leak detector, clocks or maybe an aisle light, but not enough to really affect the amperage you are plugged into.

Your RV converter is rated for a certain amperage i.e. 30 amps, 45 amps, 55 amps. In other words a 45 amp converter is capable of running 45 amps worth of 12 volt appliances in the RV. When your RV converter is working at its maximum capacity, which in this case is producing 45 amps for 12 volt appliances and accessories, it is drawing a full 8 amps out of the 30 amps available from the campground electrical supply.

If  you’re plugged in and you’re using a couple of 12 volt overhead lights (2 amps) and a ceiling fan (4 amps). In this case your converter is drawing very little from the camp grounds 30 amp electrical supply. In another scenario let’s say you’re using a lot of 12 volt overhead lights (8 amps), you’re running the furnace fan (11 amps), water pump (4 amps), TV antenna booster (8 amps) range hood fan (2.5 amps), and the battery is being charged by the converter charger (3 amps). Now, when the converter is running close to its full capacity it draws the full 8 amps from the campgrounds 30 amps, leaving you with 22 amps for other 120 volt appliances and accessories. As you can see it’s unlikely that all of this would be happening at one time. The bottom line is the converter amperage draw will fluctuate depending on the 12 volt demand placed on it.

2nd Question: I know my converter is also a battery charger so why won’t it bring my discharged batteries back to a full charge? RV converters do provide a charge to your RV house batteries, but only a small portion of the converters amperage rating is used for this. Normally 3 to 5 amps, which are not nearly enough to charge batteries that are discharged.

The converter battery charger is designed to keep the house batteries topped off with this trickle charge. Another problem with older RV converters is they charge at a fixed voltage in the range of 13.5 volts. If your batteries are fully charged this can be too much for a float charge and over time it will deplete the water level in the batteries cells. This is why it’s important to check the water level in your batteries on a regular basis, especially when you leave the RV plugged in for extended periods of time. You need a three stage charger that can provide a bulk charge then an absorption charge and finally a float charge. Newer RV converters on the market are capable of charging the batteries this way.

Here are some typical amperage draws for appliances and accessories commonly used in RV’s. This is  a basic guide to assist you in how many amps you are using at any given time. If you need to know exact amperage ratings you can check the data plate on any motors, appliances or electronic equipment you are using. This information might provide wattage requirements rather than amps. Here are a couple of simple formulas to help you convert some common electrical terms.

Wattage % Volts = Amps
Amps X Volts = Wattage

One other thing to keep in mind is many RV appliances require more amps to start the appliance than they do to run the appliance. A roof air conditioner can draw 16 amps to start, but may only use 13 amps once it is running.

120 Volt AC Amp Ratings
Appliance or Electronic Equipment Estimated Amps
Air Conditioner (X number of A/C) 12-16 Amps
Blender 5-6 Amps
Coffee Maker 5-8 Amps
Compact Disc Player 1 Amp
Computer (Laptop) 2-3 Amps
Converter 1-8 Amps
Crock Pot 1-2 Amps
Curling Iron <1 Amp
Drill 2-6 Amps
Electric Blanket 0.5-1.5 Amps
Electric Fan 1 Amp
Electric Water Heater 9-13 Amps
Electric Skillet 6-12 Amps
Hair Dryer 5-12 Amps
Iron 5-10 Amps
Light (60 watt % 120V) <1 Amp
Microwave 8-13 Amps
Microwave (Convection Oven) 13 Amps
Refrigerator in AC mode 5-8 Amps
Space Heater 8-13 Amps
Television 1.5-4 Amps
Toaster 7-10 Amps
Vacuum (handheld) 2-6 Amps
VCR 1-2 Amps
Washer/Dryer 14-16Amps
12 Volt DC Amp Ratings
Appliance or Accessory Estimated Amps
Aisle Light 1 Amp
CO Detector 1 Amp
Fluorescent Light 1-2 Amps
Furnace 10-12 Amps
LP Gas Leak Detector 1 Amp
Overhead lights (Per Bulb) 1 Amp
Porch Light 1 Amp
Power Roof Vent 1.5 Amps
Radio/Stereo 4 Amps
Range Hood (Fan & Light) 2-3 Amps
Refrigerator (LP Gas Mode) 1.5- 2 Amps
Security System 1 Amp
Television (12 volt) 4-5 Amps
TV Antenna Booster <1 Amp
TV Antenna Booster 12 Volt outlet Up to 8 Amps
Variable Speed Ceiling / Vent Fan 4 Amps
VCR Recorder / Player 2 Amps
Water Pump 4 Amp

This should clear up any confusion on the difference between using amps supplied by the campground electrical source (AC amps), and using amps supplied by the converter (DC Amps).